Installing the rear model inscription
CAUTION:
Laser beam.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Park the vehicle and the special tool 2 407 566 on a flat and even surface.
- Mount the laser on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Place special tool behind the vehicle and center.
- Align the vertical laser beam (A) and the horizontal laser beam (B) as shown on the cutout of the tail light.
- Clean the adhesive area with cleaning agent.
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
- Adhere to the air drying time of 2 min.
- Pull off the liner from the adhesive strips of the model inscription (1) .
- Align the model inscription (1) on the laser beams as shown, position it on the tailgate and press onto it.