Install rear panel
- Attach rear bumper cover (1)
while attaching and locking all connectors.
Position rear bumper cover (1) correctly.
- Clip in the rear bumper cover to the detents (1)
and (2)
.
- Clip the rear bumper cover into the detents (arrows).
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Bumper cover to underbody planking | ||
|---|---|---|
| Hexagon screw | tightening torque | 2.6 Nm |
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Bumper trim, rear | ||
|---|---|---|
| Hexagon screw | tightening torque | 2.6 Nm |
TIGHTENING TORQUE SPECIFICATION
| Bumper cover to guide, middle | ||
|---|---|---|
| Oval-head screw for thermoplastic | tightening torque | 3 Nm |
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Rear mount to bumper cover | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALLING THE TAIL LIGHT ON THE REAR LEFT SIDE PANEL .
- Refer to INSTALLING TAIL LIGHT ONTO REAR RIGHT SIDE PANEL .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .