Install support for bumper cover at front bottom
- Install support for front bottom bumper cover (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Support, bottom, to deformation element | ||
|---|---|---|
| Flat-head screw M6x20 |
tightening torque | 12 Nm |
- Guide in and correctly position cover (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Cover to holder | ||
|---|---|---|
| Hexagon screw | tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to IF INSTALLED: INSTALLING FRONT RADAR SENSOR (FRS) WITH BRACKET .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH COVERS .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to ADJUSTING THE FRONT RADAR SENSOR (FRS) .