Removing The Rear Left Side Panel

Mark and cut the separating cut (1) at the C-pillar as per dimension (a) . Disconnect only the outer panel.
Dimension (a) = 80 mm from corner of roof outer skin.
Compare position of severance cut with reinforcement plate.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Determination of separating cut using a template
Determine position of the separating cut in addition to the dimensions with the aid of a template (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Mark and cut the separating cut (1) at the door sill as per dimension (a) . Disconnect only the outer panel.
Dimension (a) = 137 mm from center point of hole with Ø 20 mm.
Compare position of severance cut with reinforcement plate.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen welded connections in areas (1) .
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Loosening bonded folded joints
Loosen the folding bonded connection in area (2) .
Loosen side panel of cavity sealing (3) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen welded connections in areas (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in area (1) . Remove side wall.

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in area (1) .
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00...
Releasing bonded connections
Release the bonded connection (2) .
Remove the lock striker reinforcement (3) .

Courtesy of BMW OF NORTH AMERICA, INC.