Installing the roof trim strip

Replacing the clamps for the roof trim strip (equipment version with CFRP roof) 

• Remove all clamps (1)  .

  All the positions of the clamps are marked with marker lines.

• Completely remove all residue adhesive tape.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure that all bonding surfaces (1)  on the roof outer skin are marked with marker lines (2)  .
• Clean bonding surfaces (1)  with the solvent cleaner and a microfiber cloth.

• Prime bonding surfaces (1)  and give a final wipe immediately with a dry microfiber cloth.

Courtesy of BMW OF NORTH AMERICA, INC.

• Allow bonding surfaces (1)  to dry for 2 mins.
• Replace the clamps (1)  .

  Parts:  Clamp

• Detach the protective film from the clamp (1)  .
• Position clamp (1)  in the center between marker lines (2)  .

  Dimension (a)  = 1 mm

• Ensure that clamp (1)  is aligned parallel to roof frame (3)  .

  Dimension (b)  = Dimension (b) 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press the clamp (1)  with both thumbs firmly and completely for at least 5 s.

• Repeat the steps with all other clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

• Check whether the clamps (1)  are present and have damage.
• Defective or missing clamps (1)  need to be replaced.
• Carefully attach the roof trim strip (1)  and clip it in at the clips (2)  starting at the rear.

Courtesy of BMW OF NORTH AMERICA, INC.