Replacing the instrument cluster (KOMBI) (After vehicle diagnosis)
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
Preliminary work
- Refer to ADJUSTING THE STEERING COLUMN POSITION .
- Refer to DEACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to REMOVING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to REMOVING STEERING COLUMN SHROUD LOWER SECTION .
- Refer to REMOVING THE INSTRUMENT CLUSTER (KOMBI) .
- Loosen all the detents (1) .
- Remove the trim (2) from the instrument cluster (KOMBI) (3) .
- Replace the instrument cluster (KOMBI) (3)
.
Parts: Instrument cluster (KOMBI)
- Position the trim (2) on the instrument cluster (KOMBI) (3) and snap it into the locks (1) .
Follow-up work
- Refer to INSTALLING THE INSTRUMENT CLUSTER (KOMBI) .
- Refer to INSTALLING STEERING COLUMN SHROUD LOWER SECTION .
- Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to INSTALLING THE STEERING COLUMN SWITCH CLUSTER (SZL) .