Installing the connecting bracket on the exhaust turbocharger for cylinders 4 to 6

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .

Do not use any metal-cutting tools.

Clean the sealing surface (1) using special tool 0 495 102 (11 4 470) .

Courtesy of BMW OF NORTH AMERICA, INC.
Clean the sealing surface (1) using special tool 0 495 102 (11 4 470) .

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing ring (1) for damage and replace where required.
Grease sealing ring (1).
INSTALLATION AID DESCRIPTION

Lubricants G14 900 ml, Can 83232360412

Courtesy of BMW OF NORTH AMERICA, INC.

Keep all the standard tools ready:

Number	Description
1	Commercially available reversible ratchet (1/4)
2	Extension (1/4)
3	Swiveling extension (1/4)
4	External Torx E8

Courtesy of BMW OF NORTH AMERICA, INC.

Guide in and install the connecting bracket (2) for cylinders 4 to 6.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Connecting brackets on exhaust turbocharger
M6	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PARTIALLY INSTALLING THE COOLANT EXPANSION TANK OF THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 4-6 .
Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
Refer to INSTALLING THE FRONT-END STRUT .