Installing windshield
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
- Prepare the glue cartridge with the standard nozzle C.
- Apply an adhesive bead within the marks (1)
on the windshield.
- Carefully feed in the windshield with the special tool 0 492 609 (51 3 010) between the hood and the windshield panel.
- Fit the windshield at top.
- Evenly align the windshield at left and right.
- Fit the windshield at the bottom and press.
- Press the windshield upward until the rubber frame of the windshield evenly makes contact with the roof.
- Secure the windshield in this installation position with the two types of yellow plastic adhesive tape (1)
.TECHNICAL DATA SPECIFICATION
Gap dimension windshield to roof outer skin 1 windshield; 2 roof outer skin 4.3+1.2-1.2 mm 5.6+1.3-1.3 mm
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT GUTTER STRIP ON THE WINDSHIELD .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to INSTALLING THE KAFAS CAMERA .
- Refer to INSTALLING INTERIOR REARVIEW MIRROR .
- Refer to INSTALLING THE COVERS FOR THE INTERIOR MIRRORS .
- Refer to CALIBRATING KAFAS CAMERA .