Removing the trim panel for the storage shelf
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
- Protect surfaces from damage.
Preliminary work
- Refer to REMOVING REAR SEAT BENCH .
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING SIDE TRIM PANEL, REAR LEFT AND RIGHT .
NOTE:
Perform the steps on the left and right side.
- Release the screw (1) from the rear end fitting (2).
- Feed out the rear end fitting (2) from the body.NOTE: Perform the steps on the left and right side.
- Unclip the cover (1) to the front.
- Unclip the outer belt feed trim (2) starting from the front and remove it.
- Release the expanding rivet (1).
- Unlock and disconnect the plug connections under the trim panel (2). Lift the trim panel (2) for that.
- Release the wiring harness with all holders from trim panel (2).
- Remove the trim panel (2) to the front and feed out the seat belts (3).