Installing the trim panel for the rear shelf
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Install trim panel (2) and guide in seat belts (3).
- Clip in the wiring harness with all the holders on trim panel (2) for the rear shelf.
- Connect all connectors and lock.
- Feed the trim panel (2) into the guides and position it correctly.
- Secure expanding rivet (1).NOTE: Perform the steps on the left and right side.
- Insert the seat belt finisher strip (2).
- Clip in the cover (1).NOTE: Perform the steps on the left and right side.
- Guide the rear seat belt end fitting (2) into the body.
- Replace the screw (1).
Part: Screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| End lining to body | ||
| M10 Replace screw. |
Tightening torque | 42 Nm |
Follow-up work
- Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .