Installing the pressure sensor on the right intake plenum

• Position the pressure sensor (2).
• Pressure sensor (2) must lock audibly on retaining tab (3).
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock connector (1) on the right pressure sensor.
• Connect and lock connector (2) on the Valvetronic servomotor.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING MOUNTING FOR DME MASTER CONTROL MODULE SUPPORT .
• Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
• Refer to INSTALLING ACOUSTIC COVER .
• Installing the cover panel of the master DME control unit.

  Courtesy of BMW OF NORTH AMERICA, INC.

  • Position the cover of the master DME control unit (1)
  • Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
• Refer to CONNECTING BATTERY GROUND LEAD .