Install the rear bumper trim

• Install the trim (2)  and clip it into the bumper cover along the dashed line.
• Tighten the screws (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper trim
  Tightening torque		2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .