Initializing the glass slide/tilt sunroof
NOTE:
TECHNICAL INFORMATION
The following prerequisites are the basis for a correct initialization and must be strictly observed.
The following prerequisites are the basis for a correct initialization and must be strictly observed.
- Press and hold the switch in the "vent position" direction.
The glass slide/tilt sunroof moves to the vent position.
- In the event of a delayed start or sudden stop of the glass slide/tilt sunroof, keep the switch pressed in the "vent position" direction.
- Continue to keep the switch pressed during the entire test module.
- After reaching vent position (A), continue to press and hold the switch for about 30 s.
The initialization starts:
- The glass slide/tilt sunroof moves from the vent position (A) in the direction of position (B).
- Screen (sliding headliner) fully closes.
- Screen (sliding headliner) fully opens.
- The glass slide/tilt sunroof moves to the "closed" position.
- The glass slide/tilt sunroof moves to the "open" position and immediately back to the "closed" position.
- After a brief pause, the screen fully closes.
The initialization is complete when the glass slide/tilt sunroof and the screen are completely closed.
- Release the switch.NOTE: TECHNICAL INFORMATION
If the switch is released in the meantime, repeat the initialization. Following successful initialization, the corresponding messages in the Check Control and the control display extinguish.- Carry out functional check (one-touch mode, anti-trapping protection and, if necessary, comfort function).