Install the lower right deformation element

• Install the bottom deformation element 
  • Feed in the deformation element (2).
  • Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Deformation element, bottom to adapter, front axle support
  M 10x60 screw	Tightening torque	40 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
• Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
• Refer to INSTALLING THE LEFT AND RIGHT AIR DUCT .
• Refer to FASTENING THE LEFT AND RIGHT EXTERNAL RADIATOR .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT SPOILER .