Preparing New Part
- Place roof outer skin on vehicle and adjust to fit.
- To keep the processing time short after applying the adhesive, have the following attachment material ready before the installation.
Mounting and adjusting the securing tool for the roof outer skin
- Variant with M7 rivet nut
:
Pull out the hold-down device (1) before installation by turning it until it reaches the same dimensions as shown.
Position the securing tool 2 469 797 over the rivet nut (2).
Join the M7 screw (3) and tighten by hand until the roof outer skin rests on the roof frame.
- Variant with mounting hole for mounting the roof rack
:
Pull out the hold-down device (2) before installation by turning it until it reaches the same dimensions as shown.
Position the securing tool 2 469 797 over the mounting hole.
Join the M7 screw connection (1) (screw, 2 washers and nut) and hand-tighten it until the roof outer skin rests on the roof frame.
- Mount and adjust securing tools 2 469 797
.
- Prepare area (1) for joining using the welding method.
- Prepare bonding surfaces (1) on the body and the new part.
Preparing the steel surface (used part and new part) for non-structural bonding
- Do not sand the bonding surface.
- Do not sand the bonding surface down to the bare metal.
- Remove coarse contamination from the bonding surfaces using cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surface with the cleaning agent R1. Adhere to the air drying time of 2 min!CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217