Insert Engine Mount

Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.
CONSUMABLE SPECIFICATION

Cleaning agent R2 500 ml 83190417324
Clean bonding surfaces on vehicle and on new part with cleaning agent R1.
CONSUMABLE SPECIFICATION

Cleaning agent R1 100 ml, Bottle 83192211217
Apply adhesive K1 to the bonding surfaces.
ADHESIVE SPECIFICATION

Body adhesive K1 195 ml 83190413015
Install the new parts with an alignment bracket or a universal mount.
During installation, ensure that sufficient adhesive has been applied to all bonding surfaces.
Rivet the new parts in the areas (1) with 3 blind rivets N1.
CONSUMABLE SPECIFICATION

Blind rivet N1
ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414

Courtesy of BMW OF NORTH AMERICA, INC.
Rivet the new part in the areas (1) and (2) with blind rivets N2,
CONSUMABLE SPECIFICATION

Blind rivet N2
ø 6.5 mm; clamping area 4.8-6.8 mm 83190301419

Courtesy of BMW OF NORTH AMERICA, INC.
Rivet the new part in the areas (1) with blind rivets N1.
CONSUMABLE SPECIFICATION

Blind rivet N1
ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414

Courtesy of BMW OF NORTH AMERICA, INC.
Position the new part and rivet it in the area (1) with N1 blind rivets.
CONSUMABLE SPECIFICATION

Blind rivet N1
ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414
Rivet the new parts in the area (2) with blind rivet N2.

Courtesy of BMW OF NORTH AMERICA, INC.

CONSUMABLE SPECIFICATION

Blind rivet N2
ø 6.5 mm; clamping area 4.8-6.8 mm 83190301419
Weld the new part in areas (3).
Avoid excessive application of heat to adhesive areas
Weld the new part in the area (1).
Avoid excessive application of heat in this process.

The cowling cross-member (2) is filled with hardly inflammable cavity foam.
In case of smoke formation: Stop the welding procedure and cool the welded area with compressed air if applicable.

Courtesy of BMW OF NORTH AMERICA, INC.
Rivet the holder (1) in the area (2) with blind rivets N1.
CONSUMABLE SPECIFICATION

Blind rivet N1
ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414

Courtesy of BMW OF NORTH AMERICA, INC.
Rivet the holder (1) in the areas (2) with blind rivets N1.
CONSUMABLE SPECIFICATION

Blind rivet N1
ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the EMC screw
Drill a hole with a diameter of 4.2 mm.
In the case of glued connections, only drill the hole after the adhesive has fully hardened.
Screw in the EMC screw.
CONSUMABLE SPECIFICATION

EMC screw SF Plus M5x15 83190301639
Seal the EMC screw with the sealant.
CONSUMABLE SPECIFICATION

Sealant D1 (seam sealing) 310ml 83422409985
Use 3 EMC screws after the adhesive hardens in the areas (1).
CONSUMABLE SPECIFICATION

screw
EMC screw, SF Plus, M5x15 83190301639

Courtesy of BMW OF NORTH AMERICA, INC.