Installing the left thrust field
- Position the left thrust field (4).
- Replace screws (2) and (3).
Parts: Screws
- Screw in screws (2) and (3) a few turns.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to body | ||
| M8 | Tightening torque | 28 Nm |
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to outer body | ||
| M10 Replace screw. | Tightening torque Angle of rotation |
56 Nm 90° |
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to door sill | ||
| M12 Replace screw. | Tightening torque Angle of rotation |
100 Nm 90° |
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to rear axle support | ||
| M10 Replace nut. | Tightening torque Angle of rotation |
56 Nm 90° |
Follow-up work
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING TANK COVER .