Remove the front output shafts (on the mobile lifting table)

NOTE: The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.

• Loosen screws (1)  .
• Remove the swivel bearing mount (2)  and set it aside.
• Hold the swivel bearing (3) with the workshop crane 2 220 718. 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release screw (1)  on the output shaft (3)  .
• Tilt the swivel bearing (2)  slightly forwards in the direction of the arrow. 

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION 
Secure component against falling.

• Position the aluminum drift (2)  on the output shaft (1)  .
• Knock out the output shaft (1)  with the aluminum mandrel (2)  and remove it from the front axle transmission.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out the output shaft (1)  in the arrow direction and remove.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the stand (1)  of the swivel bearing.
• Tighten down screws (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.