Placing the brake pads on the brake disk/putting them into operation

NOTE: TECHNICAL INFORMATION
After a brake pad exchange and before pressing the brake pedal: It is imperative to apply the electromechanical parking brake.
If this is not observed, a CC message appears and the brake system switches to the emergency program. The brake booster is no longer active.

Operate/engage electromechanical parking brake (1).

G15332736

Courtesy of BMW OF NORTH AMERICA, INC.

Depress the brake pedal (1) several times so that the brake pads are in contact with the brake disks.

G15332737

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
Refer to COMMISSIONING OR BEDDING IN OF NEW BRAKE PADS AND BRAKE DISCS (CARBON CERAMIC BRAKE) .