Installing The Reinforcement Of The B-Pillar

NOTE: TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment

Install and secure the new parts with an alignment bracket or a universal fixture.
Weld the new part in the area (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Weld new part in the areas (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of cavity sealing (expanded)
Apply sealant D1 on to the cavity sealing (1).
CONSUMABLE SPECIFICATION

Sealant D1 (seam sealing) 310 ml 83422409985
Install the new part and weld it in the areas (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of a cavity sealing (not expanding)
Apply sealant D1 on to the new cavity sealing (1). Install cavity sealing.

Courtesy of BMW OF NORTH AMERICA, INC.
Additional steps when installing the side panel:
Weld the separating cut (1), reinforcement plate and the areas (2) according to the new part preparation process.

Courtesy of BMW OF NORTH AMERICA, INC.
Additional procedures for installing the side panel can be found in the repair instructions "Replacing the rear side panel".