Installing The Rear Outer Wheel Arch Section
NOTE:
TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
- Preclean bonding surfaces on the new part and on the vehicle.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean the bonding surfaces on the new part and on the vehicle.CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive to the bonding surfaces.ADHESIVE SPECIFICATION
Body adhesive K5 50 ml 83192158654 - Install new part.
- Rivet the new part in area (1) with blind rivets.CONSUMABLE SPECIFICATION
Blind rivet N3
ø 4 mm; clamping area 1-3 mm83190301421 NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of a cavity sealing (not expanding) - Apply sealant to the new cavity sealing (1). Install cavity sealing (1).CONSUMABLE SPECIFICATION
Sealant D2 290 ml 83425A547B9