Remove Outer Wheel Arch Section With Reinforcement

Remove the cavity sealings (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Release welded connections in areas (1).
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Releasing bonded connections
Open spot-welded adhesive joints in areas (2).
Release bonded connection in area (3).
Detach the reinforcement of the B-pillar from the cavity sealing (4) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove radiator tank (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Mark and carry out the separating cut (1) as per dimension a,
Dimension a = 20 mm,

Courtesy of BMW OF NORTH AMERICA, INC.
Continue to make a separating cut (1) according to dimension a.
Dimension a = 20 mm.
Release the welded connections in the areas (2) and remove the outer wheel arch section,

Courtesy of BMW OF NORTH AMERICA, INC.