Remounting (basic) the control unit for the Front Light Electronics (FLE)
Removing the control unit for the Front Light Electronics (FLEL) (LED basic)
- Loosen screws (1).
- Feed out the control unit for the Front Light Electronics (FLEL) (2).
- Unlock plug connection (1) and disconnect.
- Remove the control unit for the Front Light Electronics (FLEL) (2).
Installing the Front Light Electronics (FLEL) control unit (LED basis)
- Check seal (3) for damage and replace if necessary.
- Position the Front Light Electronics (FLEL) control unit (2).
- Connect connectors (1) and lock.
- Feed in the Front Light Electronics (FLEL) control unit (2) and correctly position.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Front Light Electronics control unit on headlight | ||
| Screw | tightening torque | 1.5 Nm |