Fastening the anti-roll bar link and wheel speed sensor to the wheel carrier
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Position the anti-roll bar link on the wheel carrier.
- Press the control link slightly downwards.
- Replace nut (4).
Parts: Nut
- Tighten nut (4). If necessary, counter support at the Torx socket.TIGHTENING TORQUE SPECIFICATION
Rear anti-roll bar link to anti-roll bar/wheel carrier M10 Replace nut. Tightening torque 56 Nm - Clean and grease the bore for wheel speed sensor (2).CONSUMABLE DESCRIPTION
Lubricating grease Staburags NBU 12K 100 g, Tube 83 23 9 407 810 - Position the wheel speed sensor (2).
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Rear wheel speed sensor on wheel carrier M6 Replace screw. Tightening torque 12 Nm NOTE: The following step(s) must be performed if the listed component(s) is/are installed. - Hook the cable for the wheel speed sensor in the holder (3).