Replacing the eccentric screw for the control link

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Loosen nut (1).
Remove the eccentric washer (2).
Remove the eccentric screw (3).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Turning the eccentric bolts to adjust toe and camber may change the vehicle ride height. When replacing the screws, make sure the eccentric bolts are correctly positioned to keep the change in vehicle ride height during the adjustment work to a minimum.
Replace the eccentric screw (3), eccentric washer (2) and nut (1).
Parts: Eccentric screw, eccentric washer, nut
Install the new eccentric screw (3).
During replacement, position eccentric screw (3) such that the eccentric points vertically upwards.
Install the new eccentric washer (2).
NOTE: Make sure that the eccentric and eccentric washer are positioned correctly on the rear axle support.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten nut (1) to 5 Nm.