Installing the decorative trim for the M Sport steering wheel (SA710)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Position the decorative trim (2).
Connect and lock the connector for the steering-wheel heating.
Fasten the plug connection (1) for the steering wheel heating on the holder.
Check detents (2) and (3) for damage.
The detents (2) and (3) must not be damaged or missing.
Carefully clip in the decorative trim (1) at the latch mechanisms (2) and (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1) on the back of the steering wheel.

TIGHTENING TORQUE SPECIFICATION

Decorative trim to steering wheel
Screw TS5x12	Tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.