Installing left and right tie rod ends

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Description is for left component only. Procedure on the right side is identical.

Installing tie rod end

Screw the tie rod end onto the tie rod up to the dimension (A), which was determined before removal.
If necessary, hold the track rod with an open-end spanner for counter support.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATION

Tie rod end to tie rod
M10	Tightening torque	32 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Position the tie rod end (2) on the swivel bearing (3).
Replace nut (1).
Parts: Nut

Tighten nut (1). If necessary, counter support at the Torx socket.

TIGHTENING TORQUE SPECIFICATION

Tie rod end to swivel bearing
M14 Replace nut.	Tightening torque	165 Nm

Courtesy of BMW OF NORTH AMERICA, INC.