If installed: Installing the engine oil cooler

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.

Replace the sealing rings (1) from the lines (2).
Parts: Sealing ring

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install the engine oil cooler (2).

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Engine oil cooler on bumper bracket
M6X25	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the lines (2).

Tighten nuts (1).

TIGHTENING TORQUE SPECIFICATION

Lines on engine oil cooler
Nut M6	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace the rivet (1).
Parts: Rivet
Install and rivet the damper (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATION

Line clip on engine oil cooler
Hexagon screw for thermoplastic	tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Lower side cover at front
Hexagon screw for thermoplastic	Tightening torque	3 Nm