Fastening the prop shaft (partially removed)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Check centering (1) for damage and replace if necessary.
- Apply a thin coat of grease to the soft centering (1), if necessary.
The hard centering (2) must not be greased.
CONSUMABLE DESCRIPTIONLubricating grease 100 g, 83 19 0 447 Olistamoly 2 LN 584 LO Tube 919 - Replace the screws and the self-locking nuts.
Parts: Screws, self-locking nuts
- Assemble the screw connections (1) of the flexible disc (2) and the three-hole flange (3) according to the self-affixed identification.
This should prevent a humming noise from the drive train during driving.
- Hand-tighten screws and nuts (arrows), but do not tighten fully.
- Install central mount (1) into the transmission tunnel with the designation TOP facing upwards.
- Position central mount.
- Hand-tighten the bolts (1), but do not tighten fully.
- Replace screws.
Parts: Screws
- Counter-hold the screws of the flexible disc on the nut and tighten with the screws.TIGHTENING TORQUE SPECIFICATION
Front flexible disc to prop shaft M12 Replace screws.
Joining torque and angle rotation must be adhered to.
Tightening via screw.Joining torque 55 Nm Angle of rotation 90° - Secure the special tool 0 490 504 (00 9 120) with the special tool 0 495 108 (00 9 130) on the vehicle underbody and continue to screw it in according to the angle of rotation.
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATION
Central mount to body M8 Tightening torque 19 Nm