Install bumper cover, front

• Mount and position the bumper cover from the front
• Tighten the screws (1)
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper cover, front, top
  Oval-head screw M6	Tightening torque	4.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the left and right side
• Clip in the connector (2) into the holder (3)
• Connect connectors (1) and lock
• If necessary, connect and lock connector (4)

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the bumper cover into the guide and clip it in with the detents (2)
  NOTE: Perform the steps on the left and right side
• Tighten the screws (1)
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front bumper panel to fender
  Torx screws 5x35	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1)
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front bumper cover on underbody protection
  Hexagon screw for thermoplastic	Tightening torque	2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .