Preparing the rear spoiler
- Carefully remove the adhesive residue from the rear spoilerCONSUMABLE SPECIFICATION
Adhesive remover 1 L, Can 83110009712 TECHNICAL DATA SPECIFICATIONAir drying time after cleaning Cleaning agent R2 2 min - Check the rear spoiler
Do not install rear spoilers with poor fitting accuracy
Any rear spoiler positioned loosely on the tailgate must be in contact with the tailgate over the entire area and at the corners in particular
- Clean the bonding surface on the rear spoilerCONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Place adhesive strip (1) on the rear spoiler and align it
In the center of the spoiler (arrow), leave a gap of approx. 2 mm on the adhesive strip (1)
- Pull off the protective film for the bonding surface from adhesive strip (1) and stick it on the rear spoiler
- Press on the adhesive strip (1) with your thumbs or the back of your hand over the entire area since the adhesion of the adhesive tape builds up significantly through contact pressure