Install the Headunit High (HU-H)
NOTE:
RISK OF DAMAGE
Electrostatic discharge
Damage to or destruction of electrical components
Electrostatic discharge
Damage to or destruction of electrical components
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away
- Read and comply with user information on using the associated special tool 12 7 060
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol)
- For additional information see: 61 35... NOTES on ESD (electrostatic discharge) protection
NOTE:
RISK OF DAMAGE
Damage to the head unit
The hard disk of the head unit can be damaged by vibrations
Damage to the head unit
The hard disk of the head unit can be damaged by vibrations
- Carry out mechanical work on the head unit and adjacent components with care
- Position the head unit (1)
- Connect all connectors in the marked area in the correct assembly sequence and lock them in place
- Feed in the head unit (1)
upwards through the marked area
- Slide the head unit (2) forward a little and correctly position
- Tighten the screws (1) on the head unit (2)
TIGHTENING TORQUE SPECIFICATION
| Head unit on holder/holder on support | ||
| Screw | tightening torque | 1.8 Nm |
Follow-up work
- Refer to INSTALLING AUDIO CONTROL UNIT .
- Refer to INSTALLING THE STORAGE COMPARTMENT IN THE FRONT CENTER CONSOLE .
- Refer to INSTALLING THE OPERATING FACILITY IN THE CENTER CONSOLE .
- Refer to INSTALLING THE WIRELESS CHARGING STORAGE .
- Refer to INSTALLING THE DECORATIVE TRIM ON THE LEFT AND RIGHT OF THE CENTER CONSOLE .
- Refer to INSTALLING THE CENTER CONSOLE TRIM .
- Refer to INSTALLING TRIM IN STORAGE COMPARTMENT OF CENTER ARMREST .
- Refer to INSTALLING THE CUP HOLDER .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .
- Refer to INSTALLING THE CORRECT NAVIGATION MAP .
- Refer to IMPORTING THE SERVICE HISTORY .
- Refer to INITIALIZE COMPONENT PROTECTION .