Remove the module bracket rearward
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components
Scratches, surface damage
Careless handling of tools and sharp-edged components
Scratches, surface damage
- Protect working area
- Handle tools and components carefully
Preliminary work
- Refer to REMOVING REAR DOOR TRIM .
- Refer to REMOVING THE WINDOW CHANNEL STRIP FROM THE REAR DOOR .
- Secure the side window glass to the door frame when it is closed using adhesive tape
- Spread apart the holder on the outside of the side window glass with the special tool 0 496 569 (00 9 325) until the side window glass can be detached
- Shift power windows down by approximately 10 cm
- Release the detents of the door wiring harness (1) out of the rear module bracket (2)
- Unlock and disconnect the plug connections of the door wiring harness (1) on rear module bracket (2)
- Release the rubber grommet of the Bowden cable for the inner door opener (1)
- Loosen screws (2)
- Open locks (1) and remove the rear module bracket (2)