Remove right output shaft

NOTE: Description is for left component only. Procedure on the right side is identical.

Release the cable for the wheel speed sensor from the holders (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the nut (1), if necessary, counter-hold the Torx socket.
Remove the anti-roll bar link (2).
Turn steering wheel to right.

Courtesy of BMW OF NORTH AMERICA, INC.
Turn swivel bearing outwards.
Set aside the anti-roll bar link (2).
Guide out the output shaft (1) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Secure component against falling.
Position the aluminum drift (2) on the output shaft (1).
Knock output shaft (1) with the aluminum drift (2) out of the bearing support.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the output shaft (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.