Check the setting of the glass slide/tilt sunroof panel
- Check whether the distance of the glass slide/tilt roof panel to the front roof and at the rear is the same and correct if necessary.
- Slide the special tool 0 493 687 (00 9 340)
between the gasket (1) and the glass slide/tilt sunroof panel (2).
The resistance when shifting the special tool must be the same at the front and rear.
- Make sure that the glass slide/tilt roof panel at the front lies flush with the roof outer skin and is lower by a maximum of the dimension (a).TECHNICAL DATA SPECIFICATION
Gap dimension roof outer skin to glass slide/tilt sunroof panel 1 roof outer skin; 2 glass slide/tilt sunroof pane a 0.7 +0.75 -0.75 mm - Make sure that the glass slide/tilt roof panel at the rear lies flush with the roof outer skin and higher by a maximum of the dimension (a).TECHNICAL DATA SPECIFICATION
Gap dimension glass slide/tilt sunroof panel to roof outer skin 1 glass slide/tilt sunroof panel; 2 roof outer skin a 0.7 +0.75 -0.75 mm - Measure the position of the glass slide/tilt roof panel (1) to roof (2) with special tool 0 495 259 (51 0 010).