Install the DSC control unit

• Carefully mount the DSC control unit (1) on the hydraulic unit.
• Replace the screws (2).

  Parts:  Screws

• Tighten screws (2) crosswise gradually.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install holder (2).
• Replace screws (1).

  Parts:  Screws

• Insert screws (1) and tighten.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Hydraulic control unit to holder
  M6 Replace screws.	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE HYDRAULIC UNIT .
• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (VEHICLES WITH HIGH BRAKE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .