Replacing the foam cushion of the rear seat

Preliminary work

Refer to REMOVING REAR SEAT BENCH .
Refer to REMOVING ALL THE ISOFIX COVER CAPS .
Refer to REMOVING THE STORAGE TRAY .
Refer to REMOVING THE SEAT COVER FOR REAR SEAT .

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Replace the foam seat on the rear seat.
Parts: Foam cushion

Replacing the seat occupancy mats of the rear seat (SA230)

NOTE: TECHNICAL INFORMATION
The seat occupancy mats are glued to the foam pad and cannot be dismantled non-destructively.
When replacing the seat occupancy mats, new ones must always be installed with a new foam pad.

Replace the seat occupancy mats (1).
Parts: Seat occupancy mats
Place the seat occupancy mats (1) onto the foam cushion (2) and center it between the marks (arrows).
The seat occupancy mats (1) are only adhered later.
Correctly maneuver the cables of the seat occupancy mats (1) in area (3) into the foam cushion (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Turn the foam cushion (3) and, while doing so, ensure that the seat occupancy mat is not bent or kinked.

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Remount the wiring harness from the previous foam cushion (3) and connect all the connectors (1) of the seat occupancy mats.

Courtesy of BMW OF NORTH AMERICA, INC.
Clip in the wiring harness on to the inserts (2) of the foam seats (3).
Turn the foam seat.

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Check whether all the cables are fitted correctly and none show a serious bend.
Press the seat occupancy mat (1) downward in areas (2) and pull off the adhesive protective film on the rear in area (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Press the seat occupancy mat (1) in the marked area (2) for about 3 seconds.
» The seat occupancy mat (1) is adhered.

Courtesy of BMW OF NORTH AMERICA, INC.

During a subsequent assembly of the seat surface cover, ensure that the seat occupancy mats are not damaged.
Replacing heating mats of rear seat (SA4HA)

NOTE: TECHNICAL INFORMATION
The heating mat is glued to the foam pad and cannot be dismantled non-destructively.
When replacing the heating mat, a new one must always be installed with a new foam pad.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Replace the heating mats (1).
Parts: Heating mats
Position the heating mats (1) on the new foam cushion (2) and align them.
Bond heating mats (1) with the new foam cushion (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE SEAT COVER FOR REAR SEAT .
Refer to INSTALLING THE STORAGE TRAY .
Refer to INSTALLING ALL THE ISOFIX COVER CAPS .
Refer to INSTALLING THE REAR SEAT .