Remove and install left or right rear door trim panel (330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary work:

Remove door handle COVER .
Remove power window regulator ROCKER SWITCH

Attention !

Do not pull on the folding compartment.

Release screws (1).

Tightening torque 51 42 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Attention !

Risk of damage!

Tape off rear door in working area with plastic adhesive tape.

Do not pull the door trim panel too far towards the inside when it is clipped in (risk of breakage).

Loosen the door trim panel around the B-pillar using special tool 00 9 325 starting from the clips (1).

Release the door trim panel from the clamps (2).

Installation note:

Replace faulty clamps (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage Bowden cable (1) for release lever first at counter support (2) and then at door lock (3).

Installation note:

Perform function check for door inside handle with door open and rotary striker lock closed.

Feed out door wiring harness from all brackets.

Unlock and disconnect all plug connections, then remove door trim panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The centering pin (1) with the sealing ring must not be missing or damaged.

Replace faulty clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

After assembling the door trim panel proceed as follows:

Open side window
Lock with ignition key
Check for ease of movement on locking button linkage
If necessary, align linkage