Removing and installing/replacing door stop on left or right rear door (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Close door windows
- Remove front section SOUND INSULATION
NOTE:
Secure rear door against falling closed.
After disengaging door stop, use suitable means of preventing door from opening past its maximum permissible opening angle (risk of damaging paintwork or bodywork).
After disengaging door stop, use suitable means of preventing door from opening past its maximum permissible opening angle (risk of damaging paintwork or bodywork).
Pull out rubber cover (1).
Release screw (3).
Tightening torque 51 22 5AZ .
Release screw (2).
Tightening torque 51 22 3AZ .
Slide out doorstop.
Installation note:
Seal (1) must not be damaged.
Remove door stop (1) via aperture (2).
Installation note:
Following parts of door retainer (3) must not be damaged:
- Hinge
- Thread