Removing and installing/replacing rear center console cover (330i xDrive Wagon, 328d xDrive Wagon, 330i GT xDrive, 340i GT xDrive)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

IMPORTANT: Risk of damage!
If necessary, mask center console (1) and cover (2) with plastic adhesive tape.

Press special tool 00 9 325 between center console (1) and cover (2).

Unclip cover (2) towards rear.

If necessary, unlock associated plug connections and disconnect.

Remove cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latches on cover and counterparts on center console must not be missing or damaged.

Replacement (depending on version):

Modify fresh air GRILLE in rear passenger compartment (1)

Courtesy of BMW OF NORTH AMERICA, INC.
Modify 12 V CHARGING SOCKET (2)
Modify SWITCH (3)