Removing and installing/replacing wiper arm on rear window (330i xDrive Wagon, 328d xDrive Wagon)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Fold up protective cap (1) in direction of arrow.
If necessary, spread internal fixtures (2) as illustrated and remove protective cap (1).
Fixture (1) and latch mechanisms (2) of protective cap (3) must not be damaged.
Erect wiper arm (1).
Release nut (2) and detach wiper arm (1).
Tightening torque 61 62 1AZ .
Installation note:
Wiper motor must be in its end position.
Set dimension (A) to between middle of wiper arm and rear window edge.
| Vehicle series: | Dimension (A) |
|---|---|
| F11 | 30mm |
| F31 | 40mm |
Tighten nut of wiper arm with specified torque.
Tightening torque 61 62 1AZ .
Check wiper blade for damage and replace if necessary.