Removing and installing/replacing window cavity cover strip on rear door on left or right (330i GT xDrive, 340i GT xDrive)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 324
IMPORTANT:
Observe PROCEDURE for using special tool 00 9 324.
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Tape off area below window cavity cover strip with fabric adhesive tape (2).
Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).
Installation:
Seal (1) must be correctly fitted in cover strip (2).