Removing and installing or replacing trim strip on roof gutter strip at rear left or right (330i xDrive Wagon, 328d xDrive Wagon)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2019 BMW 340i GT xDrive, 2019 BMW 330i xDrive, 2019 BMW 330i GT xDrive, 2018 BMW 340i GT xDrive, and 2018 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Release rear section of trim strip on GUTTER STRIP (do not remove)

Disengage trim strip (1) in area (A) toward the bottom.

Disengage trim strip (1) in direction of arrow out of clips (2) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check all clamps for visible damage.

Following parts must not be damaged, replace if required:

Clamp
Plastic mounting
Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing (1) of side window with water.

Firstly thread in trim strip (2) behind sealing (1) then engage in clips.

Sealing (1) must not be trapped by trim strip (2) (risk of damage).

Courtesy of BMW OF NORTH AMERICA, INC.