Install timing case cover at top left

• Replace gasket (1).

  Parts  : Gasket

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the timing case cover (2).
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Sealing cap to cylinder head
  M6 x 20 screw	Tightening torque	9.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position holder (2).
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Fuel supply line to cylinder head cover/cylinder head
  M6 x 16	Tightening torque	10 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position union nut (2) and turn it a few times.
• Position screw (1) and turn it a few times.
• Tighten union nut (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Fuel delivery line to high pressure pump
  M14	Tightening torque	30 Nm

• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Fuel supply line to cylinder head cover/cylinder head
  M6 x 16	Tightening torque	10 Nm

• Replace sealing ring (1) from the coolant pump (2).

  Parts  : Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the coolant line (2) to the coolant pump.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Coolant line on coolant pump
  Screw	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE IGNITION COIL OF CYLINDER 5 .
• Refer to INSTALL THE VANOS SOLENOID ACTUATOR EXHAUST OF CYLINDER BANK 2 .
• Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
• Refer to INSTALL THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT (CHARGE AIR COOLER) .
• Refer to SEALING OFF COOLANT FOR LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT LEFT BOTTOM WHEEL ARCH COVER .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALL THE REAR TOP CROSS CONNECTION .
• Refer to INSTALL FRONT CROSS CONNECTION .
• Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING WITH THE RIGHT FRONT-END STRUT .
• Refer to INSTALLING LEFT INTAKE FILTER HOUSING WITH LEFT FRONT-END STRUT .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
• Refer to FILL THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .