Installing rear brake hose
- Fit and tighten brake hose (2) on brake caliper.TIGHTENING TORQUE SPECIFICATION
Brake hose to brake caliper, rear tightening torque 24 Nm - Hook the brake hose into holder (1).
NOTE:
RISK OF DAMAGE
Incorrect routing of the brake hose .
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail .
Incorrect routing of the brake hose .
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail .
- Do not install the brake hose in a twisted position.
- Insert the brake hose (1) in the holder on the body side.
- Ensure a correct fit of the retaining spring (2)!
- Attach and tighten the union screw (3).
TIGHTENING TORQUE SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENT THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .