Installing the windshield rubber frame
NOTE:
Perform the steps on the left and right side.
- Note mark (A) for windshield rubber frame (1) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Move lever (1) in the arrow direction and open with the special tool 0 496 529 (51 3 320) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Detach protective film (2) in stages from adhesive tape.
- Insert cover (1) into guides (3) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Place special tool with pressure rollers (1) on the window edge.
- Align cover at outer edge of windshield.
- Fit the cover and visually check for perfect position.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Move lever (1) in the arrow direction to close the special tool.
- Ensure that cover (3) is positioned correctly in guide pulleys (2) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Continue to detach protective film (1) in stages from adhesive tape.
- Use the handwheel to draw special tool in arrow direction over the entire upper edge of the window glass.