Installing the guide for the rear center bumper cover

• Put the guide for the rear center bumper cover (2)  into position.
• Tighten nuts (1)  .

TIGHTENING TORQUE SPECIFICATION

Rear center bumper cover to body
Nut and washer assembly with paint scrape groove	Tightening torque	5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the clip (2)  .
• Attach the vehicle wiring harness (1)  in all the holders.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the vehicle wiring harness (3)  on the right side of the guide for the rear center bumper cover.
• Clip in the connector housing (2)  .
• Clip in clips (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the vehicle wiring harness (2)  on the left side of the guide for the rear center bumper cover.
• Clip in clips (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.