Installing the holder on left or right

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Removing the grab handle

Expand the grab handle (1) towards the bottom.
Disengage and remove the locking Insert (2) with an angle screwdriver (3) as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Pull the grab handle (2) slightly to the inside and hold it.
Release the top and bottom release tab (1) with a suitable screwdriver (3) in the arrow direction respectively.
Guide the grab handle (2) out.
Repeat the operation on the other side of the grab handle (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Installing the grab handle

Insert the grab handle (1) into the body.
Snap in the grab handle (1) correctly, as otherwise the locking inserts (2) cannot be locked in place in correctly.
Engage the locking inserts (2) on both sides of the grab handle (1).

Courtesy of BMW OF NORTH AMERICA, INC.