Removing special tool from the cylinder head
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen screws (1).
- Guide the special tool 2 459 012
out and remove.
- Feed in and install the wiring harness section (1) for sensor system 2.
- Make sure that you can hear the locks (arrows) engage.