Partially removing the radiator of high-temperature coolant circuit
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Materials harmful to health
.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
NOTE:
TECHNICAL INFORMATION
Follow notes for repair work on the cooling system.
For additional information see: NOTES FOR WORKING ON THE COOLING SYSTEM
Follow notes for repair work on the cooling system.
For additional information see: NOTES FOR WORKING ON THE COOLING SYSTEM
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Loosen screw (1).
- Release the screw (1) of the air conditioning condenser.
- Detach the air conditioning condenser (1) from the rubber mounts (2) In the arrow direction and set It to the side.
- Unlock and disconnect the coolant line (1).
- Catch and dispose of escaping coolant.
- Unlock and disconnect the coolant line (1).
- Catch and dispose of escaping coolant.
If installed: Detaching the coolant lines from the external radiators
- Unlock coolant line (1) and detach.
- Catch and dispose of escaping coolant.
- Unlock coolant line (1) and detach.
- Catch and dispose of escaping coolant.
- Version with automatic transmission:
Release the transmission oil lines (1) at left and right from the brackets (2).
- Tilt radiator (1) of the high-temperature coolant circuit in the arrow direction.
- Press radiator (1) of the high-temperature coolant circuit in the lower area in the arrow direction and guide it out of holders (2).
- Guide out radiator (1) of the high-temperature coolant circuit carefully
in the arrow direction and remove it.